Ultraxide Liquid Disinfectant

Directions Of Use

Surface Disinfection:

Situations:

• Empty animal sheds, cages and pens, free from litter, manure and portable equipment.
• Saleyards, abattoirs, floors, walkways, rubbish bins & transport vehicles.

Rate:

• 10mL per 1L of water (1:100 dilution rate).
• Saturate all surfaces using low-pressure spray equipment and allow them to dry or be absorbed. 

Critical Comments: 

• Remove all animals and birds before use.
• Clean the area with an appropriate cleaning product to remove gross soiling.
• Remove or raise feeder & drinking equipment. Do not use it on feeding troughs, drinking equipment, or drinking water. 
• Wear Personal Protective Equipment (PPE).
• Prepare a working solution by diluting the product in water to the appropriate concentration and stirring until the solution is completely mixed.
• Use the solution immediately after preparation. If not used immediately, stir the solution before use. The solution can be used up to 5 days after preparation.
• Saturate all surfaces using low-pressure spray equipment and allow them to dry or be absorbed. Apply the solution to the dry floors and walls using a pressure sprayer at an application rate of 300ml/m². 
• Keep the area well ventilated during application and drying.
• Ventilate the area thoroughly before re-entry. 
• Persons not wearing the recommended PPE should not enter the area for 24 hours after application.
• To clean spray equipment after use (e.g. pumps and sprayers), an alkaline cleaner followed by a water rinse is recommended.

Cleaning and Disinfection of Vehicles/Equipment:

The exterior of the Vehicle:

Remove any mud, straw, or dirt deposits from the wheels, wheel arches, mudguards, and exposed vehicle chassis.

• Remove all food, bedding, and dung from the trailer bed with brushes, scrapers, or shovels.
• Clean the vehicle’s exteriors by starting at the top of the vehicle and working down each side, paying special attention to the wheel, wheel arches, and mudguards.
• Wash using a power washer after using detergent.
• After washing is complete, a high-pressure rinse should follow in cleaning all surfaces with clean water and checking to ensure there is no muck or debris.
• Once dried, spray Ultraxide at a 1:100 Dilution rate or send the vehicle through the disinfection spraying arch for thorough disinfection of all the exteriors, including the undersides.

Interior of the Vehicle:

• Take out all removable items and brush any debris or mud into a bucket or dustpan.
• Wash the floor of the vehicle floor mats and vehicle pedals with detergent.
• Use a piece of clean cloth soaked in a disinfectant solution such as Ultraxide 1:100 to disinfect the cab floor, mats, and foot pedals or spray Ultraxide at 1:100 solution.
• All items removed from the vehicle must also be cleaned and disinfected in a similar manner.

Wheel Dips:

• Treat all vehicles as potentially contaminated, no matter how clean they appear when arriving.
• Set up a separate area for pick-up and delivery of livestock.
• Make all vehicles pass through a wheel dip (which must cover enough length to make the entire wheel wet with UltraxideTM at a 1:100 dilution rate.
• The wheel dip solution must be changed weekly or at a higher frequency in cases of heavy soiling.
• Wheel dip should be protected from direct sunlight and rainwater.

Foot Dip:

• First, soil & dirt should be well clean by using a brush & with clean water.
• Make a walk-through foot dip with UltraxideTM at a 1:100 dilution rate.
• The Foot bath should be cleaned and filled with fresh disinfectants once every five days, depending on the contamination level.
• The Foot bath should be protected from direct sunlight & rainwater.

How to Prepare and use Ultraxide for Boot Dip:

• Collect 5L of water.
• Fill a suitable container with the water and Ultraxide.
• Stir thoroughly until the solution is completely mixed.
• Provide two brushes to dry and wet clean.
• Remove organic matter from boots and soles.
• Pay particular attention to the water. Also, remember to pay close attention, particularly to the soles.
• Apply Ultraxide solution by covering the foot of the boot for 1 minute.
• Replace Ultraxide solution once soiled or every five days if unused.

Rates are a general guide only.  Before opening, carefully read Ultraxide Liquid Disinfectant directions for use or the Ultraxide Liquid Disinfectant Brochure, precautionary and protection statements, storage and disposal, safety directions and first aid instructions.  The product is designed for the particular purpose indicated on the label. Failure to use the product strictly as directed may be illegal, dangerous and render the product ineffective.