Tank and Equipment Cleaner

Tips For Use

General Use:

Flush out sprayer with clean water. Half fill the spray tank and commence agitation. Slowly add the required quantity of Tank and Equipment Cleaner. Top up the tank and agitate vigorously for 15 minutes. Use hand lance or return hose (where suitable) to clean top of tank around filter basket etc. Open spray booms and spray out. With persistent chemicals or when cleaning at end of season, allow mixture to stand overnight before spraying out. When sprayer is to be re-used immediately, re-fill the tank with water, agitate for 5 minutes and spray out. When storing sprayer for any length of time, do not give final rinse until required for use, as Tank and Equipment Cleaner leaves a protective film.

Stain Removal:

To remove stubborn spray stains on the outside of the tank, on tractors or other machinery. Mix Tank and Equipment Cleaner in a bucket and, using rubber gloves, vigorously scrub the affected areas with the solution, using a stiff scrubbing brush.

General Instructions:

This product will generate heat and become unstable if it comes into contact with small amounts of moisture.To avoid hazardous situations please handle this product carefully and observe the following:

• Ensure that maximum agitation is running prior to adding product to spray tank.
• Ensure that spray tank is at least half full of water before adding product to tank.
• Ensure that the filter basket is removed before adding through top port of tank.
• Ensure that the required quantity of product is measured out using a dry measuring vessel.
• Ensure that product is promptly resealed after required quantity is measured out.

Storage:

• When storing, Always store in closed, original container in a cool, well ventilated area out of direct sunlight.

Safety Directions:

• Corrosive Product is poisonous if swallowed. 
• The product is alkaline. 
• Attacks skin and eyes. 
• May produce severe burns. 
• Will irritate the throat. 
• Do not inhale vapour. 
• Ensure adequate ventilation when using. 
• Avoid contact with skin, eyes and clothing. 
• When preparing and using solution wear elbow length neoprene gloves, face shield or goggles. 
• Do not mix with hot water. 
• Do not mix with other chemicals. 
• Do not mix with different types of chlorinating chemicals. 
• Mix with water only. 
• If product or solution is on skin, immediately wash area with soap and water. 
• In case of spillage, flush with large quantities of water. 
• Wash hands after use. 
• After each day’s use wash gloves, face shield or goggles and contaminated clothing.

First Aid:

• If poisoning occurs, contact doctor or Poisonous Information Centre on 131 126. 
• If swallowed do not induce vomiting. 
• Give glass of water. 
• If skin contact occurs, remove contaminated clothing and wash skin thoroughly. 
• If in eyes, hold eyes open, flood with water for at least 15 minutes and see a doctor.
• Additional information is listed in the Safety Data Sheet (SDS)