Tips For Use
- Surefire Tempra 750 WG Herbicide (Halosulfuron) should be applied to actively growing weeds when new growth has reached a minimum of 5cm of new leaf growth for Nutgrass or 2cm for Mullumbimby couch.
- Apply follow-up treatments if sufficient new growth warrants retreatment.
- Irrigation or rainfall within two hours of application will reduce control.
- Drought stress after treatment may also reduce control.
- Symptoms of weed control are a gradual yellowing of foliage and seed heads followed by desiccation. Initial symptoms may take 7-10 days to be noticeable, with full effects occurring 4 to 6 weeks after treatment.
Restraints:
- Do not apply more than 200 g/ha per season.
- Do not apply after the onset of frosts.
- Do not apply this product through any type of irrigation system.
- Do not apply if heavy rain is expected within 48 hours.
- Do not apply to paddocks where there is a high risk of weeds resistant to group B herbicides.
- Do not make more than one application of a group B herbicide per season.Â
Surefire Tempra 750 WG Herbicide (Halosulfuron) is compatible with Glyphosate, Diclofop-Methyl, Dicamba/MCPA and Bromoxynil/MCPA mixtures and amine formulations of 2,4-D. Read and follow all label directions, restraints, plant-back periods, withholding periods, regional use restrictions and safety directions for the tank mix products.
Tank mixing with paraquat or ametryn may result in reduced weed control.
Organophosphate insecticides should not be tank-mixed or applied 7 days prior or 3 days after application of Surefire Tempra 750 WG Herbicide (Halosulfuron), as severe crop injury may result.Â
Plant Back Intervals:
The following crops may be planted at specific time intervals following application of approved rates of Surefire Tempra 750 WG Herbicide (Halosulfuron) in approved situations. Use the time intervals listed below to determine the required time interval before planting.
Crop |
Plant back interval after the last application of Tempra Herbicide |
Corn/Maize, Sorghum and Sugarcane |
2 months
|
Wheat |
3 months
|
Cotton |
4 months
|
All other crops (except Sugarbeet) |
24 months
|
Sugarbeet |
36 months
|
Protection of Crop, Native and Other Non-Target Plants:
- Avoid spraying of non-target vegetation. In turf, do not use clippings from treated areas for mulching around vegetable or fruit trees.
- Do not apply under weather conditions, or from spraying equipment, that may cause spray to drift onto nearby susceptible plants/crops, cropping lands or pastures.
- After spraying, the first flush irrigation tailwater or stormwater run-off from land treated with Tempra Herbicide should be prevented from entering waterways.
- Where farms do not have the capacity to retain run-off, do not irrigate to the point of run-off for at least 6 days after application.
Protection of Livestock, Wildlife, Fish, Crustacea, the Environment and Others:
- Do not contaminate dams, rivers, or streams with the product or used container.
- Do not feed grass clippings from treated areas to poultry or other livestock or allow grazing of treated turf.Â
- Keep people and pets off treated areas until the spray solution has dried.
- Tempra Herbicide is very highly toxic to duckweed.
Storage:Â
- Store in the closed, original container in a cool, well-ventilated area.
- Do not store for prolonged periods in direct sunlight.
Safety Directions:
- Harmful if swallowed.
- Dust will irritate the eyes.
- Avoid contact with eyes and skin.
- Wash hands after use.
First Aid:
- If poisoning occurs contact a doctor or Poisons Information Centre. Phone Australia 131 126.
- For further information, refer to the Safety Data Sheet (SDS).
This information and product advice is not intended to be advice or recommendations for any specific use or circumstance. You should seek specialist advice before using any product. Always follow the manufacturer’s guidelines. Specialist Sales liability is limited.​
Withholding Period
Withholding Period Details (WHP):
Harvest:
- Turf:Â Do not use clippings from treated areas for mulching around vegetables or fruit trees. Do not feed grass clippings from treated areas to poultry or other livestock.
- All other crops:Â Not required when used as directed.
Grazing:
- Sorghum:Â Do not graze livestock or cut for fodder or forage for four (4) weeks after treatment.
- Turf:Â Do not allow grazing of treated turf.
- Pasture:Â Do not graze livestock or cut for fodder or forage for ten (10) weeks after treatment.
- All other crops:Â Not required when used as directed.
Hayley (verified owner)
Excellent service, good price
Upvote if this was helpful (0) Downvote if this was not helpful (0) Watch Unwatch Flag for removal
Peter Kirwin (verified owner)
Appears to have done the trick.
Upvote if this was helpful (0) Downvote if this was not helpful (0) Watch Unwatch Flag for removal
Roger Benton
I think your pitiful micro inclusion of “how to directions and safety use” for the 25g packet of
TEMPRA 750 G may leave you exposed to anyone who thinks they may have a claim for personal health damage and or crop/lawn damages? In these days of litigation I find it beyond comprehension that you would do this.
Incidentally your directions on line (which are legible) defy all my efforts to print? Eg “Ctrl p”
Upvote if this was helpful (0) Downvote if this was not helpful (0) Watch Unwatch Flag for removal
specialistsales
Hi Roger, and thanks for your review of Tempra 750WG Herbicide. Specialist Sales is the reseller for Tempra, not the manufacturer, so we suggest you take up any issues with the product’s packaging with PCT International (ph 0737 117 022). We are not responsible for the packaging or the directions of use that are supplied with the product. These have been approved by the APVMA when the product is registered for sale in Australia. The ‘Directions of Use’ and ‘SDS’ for Tempra can be viewed, downloaded and printed. If you go to product and open it, you will see a list of tabs down the left-hand side of the page. Click on the ‘SDS & Technical’ tab and select the document you wish to view. You can then download and print the document. Ctrl+P will only be effective once you have the document open.
Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal