15ml Dial-a-Dose Injector (PAS1263)

Tips For Use

Before Use: 

• Always read the label.
• Check the label on the pharmaceutical manufacturer’s container for dose rates, precautions, and safety information before use.
• Use only the recommended dose rate.
• Use only the pharmaceutical manufacturer’s recommended rates. 
• Refer to the pharmaceutical manufacturer’s dose rate chart or specification. 

Important:

• Do not store your applicator or feed tube full of product.
• Clean as per the “After Use” instructions.

Priming The Injector: 

• As this is a dial-a-dose instrument, the dose must be set at maximum to prime the instrument. 
• This must be repeated every time a new container of material is used.

To Set The Dose:

• The dose can be set from 0.5ml to 15ml in 0.5ml increments. 
• The dose is very easily set. 
• Turn the dose adjustor to the required dose number in the visible window.
• Once the dose is set, squeeze the handle and lever and check that the front of the piston stops at the required dose.
• Ensure the handle and lever are fully open before changing the dose. 
• Do not squeeze to change the dose, which will damage the instrument.

Accessing Internal Parts:

• Holding the instrument to access the internal parts is important, as the return spring will force the handle and lever apart under pressure. 
• Remove the handle clip by sliding it out of the groove in the handle. 
• When the pushrod assembly comes free of the handle, access is then able to be made to the inlet valve spring assembly and to clean or replace the piston o-ring. 
• When re-assembling, ensure the piston o-ring is lubricated with NJ Phillips Lubricant, then slide the pushrod assembly back into the handle, ensuring the return spring is located correctly in the handle and lever set. 
• Then, secure the pushrod assembly by sliding the handle clip back into the slot within the handle.

Superior Valve Design:

• The inlet valve is housed in the front of the push rod and is accessed by removing the inlet valve spring assembly by holding the spring and turning in an anticlockwise direction to pull out of the front of the piston. 
• To reassemble once cleaned or being replaced, re-lubricate with NJ Phillips Lubricant, locate the inlet valve of the assembly into the front of the piston and gently twist and push the valve spring assembly into the retaining clips.
• The delivery valve is located at the rear of the needle mount or drench nozzle. 
• The delivery valve may be readily removed for cleaning.

Visible Dose:

• A transparent graduated cylinder provides an instant check of the dose.

Needle Mount & Nut:

• The injector is fitted with a metal needle mount and Luer lock nut. 
• To fit the needle, ensure the needle nut is screwed all the way onto the end of the cylinder. 
• Locate your needle onto the mount and twist clockwise to lock it into place. 
• To remove the needle, twist it in an anticlockwise direction.

This information and product advice is not intended as advice or recommendations for any specific use or circumstance. You should seek specialist advice before using any product. Always follow the manufacturer’s guidelines. Specialist Sales liability is limited.​